BEC w/ 3P cable – Sequre

Description

BEC w/ 3P cable – Sequre

SOLDERING REQUIRED
See below for proper pinout

We can not accept returns after this BEC has been soldered.  We are not responsible for any electronics that are plugged into this BEC improperly.  Be sure to check everything before and after you solder to be sure the polarity and pinouts are correct.

BEC
Product Size: 23*18*7mm
Net Weight Of Product: 4g
Package Size: 80*70*8mm
Packing Weight: 5g
Package Size (Including Outer Carton)：200*110*40mm
Packing Weight (Including Outer Carton)：49g
Input: 6-35V
Output: 5, 6, 7.2, 8.2v @ 4amps or 12v @ 3amps

3P Cable (NOTE: White signal wire not used for this BEC)
Product Size: 155mm
Net Weight Of Product: 3g
Package Size: 110*70*8mm
Packing Weight: 4g
Package Size (Including Outer Carton)：200*110*40mm
Packing Weight (Including Outer Carton)：48g

Soldering instructions:

INPUT gets soldered to the + and – on the side of the BEC.  Be sure you do not reverse polarity.

Solder the jumper for the output voltage level you need.  If you are using standard servos, do not solder anything to get 5vdc.
WARNING:  DO NOT PLUG INTO RECEIVER IF USING ANY VOLTAGE ABOVE 5V UNLESS YOU ARE SURE IT CAN HANDLE THE HIGHER VOLTAGE.  Same goes for your servos.  Only plugin servos that are rated for the voltage set on this BEC.

Then solder the 3P cable to the bottom of the BEC.
BLACK wire gets soldered to the G on the BEC
RED wire gets soldered to the V on the BEC
White wire is not used.  Best to cut it off or insulate it so it does not accidentally ground out anywhere.